Long-term Memory

Cisco switches are very verbose in their layer 1 error reporting as shown in the output below:

FastEthernet0/1 is down, line protocol is down
  Hardware is Fast Ethernet, address is 0030.94bd.4041 (bia 0030.94bd.4041)
  MTU 1500 bytes, BW 0 Kbit, DLY 100 usec, rely 255/255, load 1/255
  Encapsulation ARPA, loopback not set, keepalive not set
  Duplex setting unknown, Unknown Speed, 100BaseTX/FX
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input never, output 00:35:31, output hang never
  Last clearing of "show interface" counters never
  Queueing strategy: fifo
  Output queue 0/40, 0 drops; input queue 0/75, 0 drops
  5 minute input rate 0 bits/sec, 0 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     1 packets input, 64 bytes, 0 no buffer
     Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
     0 watchdog, 0 multicast
     0 input packets with dribble condition detected
     3 packets output, 444 bytes, 0 underruns
     0 output errors, 0 collisions, 1 interface resets
     0 babbles, 0 late collision, 0 deferred
     0 lost carrier, 0 no carrier
     0 output buffer failures, 0 output buffers swapped out

On this page on the Cisco website, there is a table listing all error counters and their meaning for Ethernet interfaces.

When experimenting with Cisco routers, it’s very nice to have a (small) lab environment to test things. Unfortunately, Cisco routers tend to be fairly expensive and noisy, especially if you need 5 or more of them. So I was looking for a cheaper and more flexible solution.

Dynamips is a Cisco router emulator which loads an official Cisco IOS-image and runs it on emulated hardware. It started out as an emulation of 7200 routers only, but now supports 3600 and 2600 series as well.

When you want more than a single router, you’ll need dynagen as well. Dynagen connects to a running dynamips instance and does some magic to get the (emulated) ethernet-ports connected to wherever you specify. The network-topology is created using plain text files. While this seems scary at first, the excellent tutorial covers every frequently used scenario.

Both tools are Open Source software and run on Linux and Windows (although it needs cygwin and doesn’t run as stable). The only catch is that you need real Cisco IOS images. The cisco.com site provides downloads only to selected users. Another way to get them is to copy them from a real router.

Continue reading ‘Emulating a router: dynamips’ »